Sunday, June 19, 2011

SOLD :)

On a Wing and a Prayer... hand chased & repousse "motto" banner of recycled aluminum mounted on a wedge of rustic weathered wood. 

Approx 8"L x  1"H.
Click photo to zoom.
Available at Big Mama's Hula Girl Gallery in Grayton Beach, FL.

1 comment:

02cpsoww4i said...

It’s crucial to note that retraction settings are relative to print size and form complexity – you will need to adjust accordingly. The retraction settings are in all probability too low if you have strings, blobs, or zits. Try rising the retraction pace and reducing the retraction distance and see if it helps. Alternatively, you can also make|you could make} helps easier to remove by reducing the flow fee, which, if carried out right, won’t over-compromise the bond between layers (a flow fee that's too low may cause issues with inter-layer adhesion). To make issues easier, {you can also|you could also|you can even} retrofit a bed levelling sensor in case your 3D printer hasn’t received Freediving Fins one –check out these sensorsfor ideas.